Civic Sedan L4-1.5L SOHC (VTEC) (1995)
/Page-1230007.png)
11. Center the steering rack with its strokes.
12. Make sure that the cable reel of the SRS is centered as follows:
-
Turn the steering wheel left approx. 1 50 degrees, and check the cable reel position.
-
If the cable reel is centered, the yellow gear tooth lines up with the alignment mark on the cover.
-
Return the steering wheel right approx. 1 50 degrees to the straight ahead position.
13. Slip the lower end of the steering joint onto the pinion shaft (line up the bolt hole with the groove around the shaft) and tighten the steering joint
bolts.
NOTE: Connect the steering shaft and pinion with the cable reel and steering rack centered.
-
Be sure that the lower steering joint bolt is securely in the groove in the steering gearbox pinion.
-
If the steering wheel and rack are not centered, reposition the serrations at the lower end of the steering joint.
14. Install the steering joint cover with the clamps and clip.
