Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-481002.png)
Standard (New):
Intake: 0.017 - 0.050 mm (0.0007 - 0.0020 inch)
Exhaust: 0.018 - 0.054 mm (0.0007 - 0.0021 inch)
Service Limit: 0.08 mm (0.003 inch)
4. Repeat these measurements on all the rockers.
-
If the clearance is over the service limit, replace the rocker shaft and all over-tolerance rocker arms.
Inspection Using Special Tools
CAUTION:
-
Before using the Valve Inspection Tool, make sure that the air pressure gauge on the air compressor indicates over 400 kPa (4 kgf.cm, 57 psi).
-
Inspect the valve clearance before rocker arm inspection.
-
Cover the timing belt with a shop towel to protect the belt.
-
Check the intake primary rocker arm of each cylinder at TDC.
1. Remove the cylinder head cover.
2. Plug the relief hole with the special tool.
3. Remove the sealing bolt from the inspection hole and connect an air pressure regulator with a 0 - 100 psi gauge.