Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-1941003.png)
6. Position the rotor pulley squarely over the field coil. Press the rotor pulley onto the compressor boss with the special tool. If the rotor pulley does
not press on straight, remove it, and check the rotor pulley and compressor boss for burrs or damage.
CAUTION: Maximum press load: 39,200 kPa 1400 kg/sq.cm, 5,690 psi)
7. Assemble in the reverse order of disassembly. Make note of the following items.
-
Install the field coil with the wire side facing down.
-
Clean the rotor pulley and compressor sliding surfaces with non-petroleum solvent.
-
Make sure the snap rings are fully seated in the groove.
-
Make sure that the rotor pulley turns smoothly after it's reassembled.
-
Route and clamp the wires properly or they can be damaged by the rotor pulley.
