Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-1110004.png)
3.
Under the dash, detach the inner cable end from the accelerator pedal bracket. Discard the old throttle cable.
4.
From the engine compartment, feed a new throttle cable (see PARTS INFORMATION) through the bulkhead, then push and twist the grommet
into place. Install the cable in its guide brackets.
5.
Attach the inner cable end to the accelerator pedal.
6.
Open the throttle valve fully, then attach the inner cable to the throttle link, and install the cable in the bracket without tightening the locknut.
7.
Turn the adjusting nut until you have 10 to 12 mm of cable deflection, then tighten the locknut.
