Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-1815002.png)
4. Check for wear, burrs and other damage to the edges of the grooves in the sleeve.
NOTE: The pinion shaft and sleeve are a precision matched set. If either the pinion shaft or sleeve must be replaced, replace both parts as a set.
5. Remove the circlip and pinion shaft sleeve from the pinion shaft.
6. Using a cutter or an equivalent tool, cut and remove the four seal rings from the sleeve.
CAUTION: Be careful not to damage the edges of the sleeve grooves and outer surface when removing the seal rings.
