Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-1840021.png)
50. Set the selected 32 mm shims on the bearing surface of the gearbox housing.
51. Coat the new O-ring with grease, and carefully fit it on the valve housing.
52. Apply grease to the needle bearing in the gearbox housing.
53. Install the valve body unit on the gearbox housing by engaging the gears.
NOTE: Note the valve body unit installation position (direction of line connection).
54. Tighten the flange bolts to the specified torque.
55. Install the cylinder lines A and B.
NOTE:
-
Clean the joints of the cylinder lines A and B thoroughly. The joints must be free of foreign material.
-
Install the cylinder lines A and B by fighting the flare nuts by hand first, then tighten the flare nuts to the specified torque.
56. Grease the sliding surface of the rack guide, and install it onto the gear housing.
57. Apply a thin coat of grease to the new O-ring, and install it on the rack guide screw.
58. Install the spring, rack guide screw and locknut on the gear housing.
