Civic Sedan L4-1.6L SOHC (VTEC) (1996)
/Page-1841008.png)
NOTE: After installing the cushion, wipe off any excess adhesive that may have dripped into the inside of the cylinder housing.
ASSEMBLE
NOTE:
-
Clean the disassembled parts with solvent, and dry them with compressed air. Do not dip the rubber parts in solvent.
-
Always replace the non-reuseable parts with new ones before assembly.
-
Do not allow dust, dirt, or other foreign materials to enter the steering gearbox.
1. Apply a thin coat of grease to the inside surface of the rack end bushing. Grease quantity: 1 - 3g (0.04 - 0.1 oz).
CAUTION: Do not fill the slots with grease; they must remain open to serve as air passages.
2. Install the rack end bushing by aligning the round projection on the bushing with the hole in the cylinder housing
3. Grease the steering rack teeth.
