honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Air Door Cable, HVAC > < Air Mix Control Motor|Page 6599
Page 1
background image

Air Door Actuator / Motor: Service and Repair
Mode Control Motor

1. Disconnect the 7P connector from the mode control motor.
2. Remove the rod from the arm of the mode control motor.
3. Remove the two self-tapping screws and the mode control motor.
4. Install in the reverse order of removal. After installation, make sure the mode control motor runs smoothly.

Air Door Cable, HVAC > < Air Mix Control Motor|Page 6599