Civic Wagon 2WD L4-1493cc 1.5L SOHC (D15B2) TBI (1988)
_tbi/Page-643003.png)
^
Use the aligning bar tool to ensure that the lathe moves square to the center of the brake disc. The disc should turn toward the cutting bits.
^
Use "Kwik-Way" cutting bits (P/N KW109-1092-23, H/C 5418866) and the holding screws that come with them. These bits are stamped "K W."
They can be purchased from American Honda using normal parts ordering procedures, or by contacting a Kwik-Way distributor. The Kwik-Way P/N
is 109-1092-23.
^
Before using the lathe, inspect the tips of the cutting bits with a magnifying glass to make sure they are not worn out. Each bit has three tips.
^
Do not set the cutting depth on the lathe to more than 0.2 mm (0.008 in.) This is two divisions on the cutting knob.
^
To refinish, the transmission must be in first gear (D3 or D4, if the shift selector doesn't have a first gear position; second gear on Preludes with
ATTS), with the engine at idle (not fast idle). If the transmission and engine are at higher gears and speeds, you will damage the cutting bits.
Rear Brake Discs
Refinish rear brake discs off the car with conventional disc refinishing equipment.
WARRANTY CLAIM INFORMATION [NEW]
None; information only.
