CR-V 2WD L4-2.4L (2003)
Power Door Lock Switch: Testing and Inspection
Door Lock Knob Switch
Door Lock Knob Switch Test
1. Remove the driver's door panel.
2. Identify the type of door lock actuator.
3. Disconnect the 3P connector from the actuator.
4. Check for continuity between the No.1 [No. 2] and No.3 [No. 1] terminals:
-
There should be continuity when the door lock knob switch is in the LOCKED position.
-
There should be no continuity when the door lock knob switch is in the UNLOCKED position.
[] : Mitsui Type
5. Check for continuity between the No.1 [No. 2] and No.2 [No. 3] terminals:
-
There should be continuity when the door lock knob switch is in the UNLOCKED position.
-
There should be no continuity when the door lock knob switch is in the LOCKED position.
[] : Mitsui Type
6. If the continuity is not as specified, replace the driver's door lock actuator.