CR-V 2WD L4-2.4L (2003)
86. Hold the gearbox housing using a C-clamp, then install the special tool on the lock screw (A). Retighten the lock screw to specified torque values.
Remove the special tool.
87. Retighten the 12 mm flange bolts (A) to specified torque values.
88. After tightening the 12 mm flange bolts, install a new stop washer (B) over one of the bolt heads (C). Be sure the tabs (D) of the stop washer are
aligned with the flat surfaces (E) of the bolt head.
89. Clean off any grease or contamination from the boot installation grooves around on the housing.
90. Expand boot (A) by removing the vinyl tape, and fit the boot ends (B) in the installation grooves on the cylinder housing.
