CR-V 2WD L4-2.4L (2003)
9. If the old quarter glass will be reinstalled (and either clip is broken off the molding), seal the body holes with pieces of urethane tape (A). Then set
the quarter glass upright in the opening, and make alignment marks (B) across the quarter glass and body with a grease pencil at the three points
shown. Be careful not to touch the quarter glass where adhesive will be applied.
10. Remove the quarter glass.
11. With a sponge, apply a light coat of glass primer to the inside face of the quarter glass (A) as shown, then lightly wipe it off with gauze or
cheesecloth:
-
Do not apply body primer to the quarter glass, and do not get the body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from the primed surfaces.
12. With a sponge, apply a light coat of body primer to any exposed paint around the windshield opening flange. Let the body primer dry for at least
10 minutes;
-
Do not apply body primer to the remaining original adhesive, and be careful not to mix up glass and body primer sponges.
-
Never touch the primed surfaces with your hands.
