CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Brake Pad: Service and Repair
WARNING:
-
Never use an air hose or dry brush to clean brake assemblies.
-
Use an OSHA approved vacuum cleaner to avoid breathing brake dust.
1. Loosen the front wheel nuts slightly, then raise the vehicle and support it on safety stands. Remove the front wheels.
2. Remove the caliper bolt, and pivot the caliper up out of the way. Check the hoses and pin boots for damage and deterioration.
3. Remove the pads, pad shims and pad retainers.
4. Using vernier calipers, measure the thickness of each brake pad lining. The measurement does not include the pad backing plate thickness.
Brake Pad Thickness:
Standard: 10.5 - 11.5 mm (0.41 - 0.45 inch)
Service Limit: 1.6 mm (0.06 inch)