CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
11. Push in the piston so that the caliper will fit over the pads. Make sure that the piston boot is in position to prevent damaging it when pivoting the
caliper down.
12. Pivot the caliper down into position, being careful not to damage the pin boot. Install the caliper bolt and tighten it.
13. Depress the brake pedal several times to make sure the brakes work, then road-test.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
applications of the brake pedal will restore the normal pedal stroke.
14. After installation, check for leaks at hose and line joints and connections, and retighten if necessary.
