CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
-
If the components deploy and the green light on the tool comes on, continue with this procedure.
-
If a component doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Disposal of Damaged components.
-
During deployment, the airbags can become hot enough to burn you. Wait 30 minutes after deployment before touching the airbags.
Deployment Tool Check Procedure
Deployment Tool Check
1. Connect the yellow clips to both switch protector handles on the tool; connect the tool to a battery.
2. Push the operation switch: green means the tool is OK; red means the tool is faulty.
3. Disconnect the battery and the yellow clips.
Disposal of Damaged Components
Disposal of Damaged Components
1. If installed in a vehicle, follow the removal procedure for the driver's airbag, front passenger's airbag, side airbag, seat belt tensioner, and seat belt
buckle tensioner.
2. In all cases, make a short circuit by cutting, stripping, and twisting together the two inflator wires.
NOTE: The driver's and passenger's airbag each have four wires: twist each pair of like-colored wires together
3. Package the component in the same packaging that the new replacement part came in.
4. Mark the outside of the box "DAMAGED AIRBAG NOT DEPLOYED", "DAMAGED SIDE AIRBAG NOT DEPLOYED", "DAMAGED SEAT
BELT TENSIONER NOT DEPLOYED" or "DAMAGED SEAT BELT BUCKLE TENSIONER NOT DEPLOYED" so it does not get confused
with your parts stock.
5. Contact your Honda District Service Manager for how and where to return it for disposal.
