CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
8. Install the ball joint boot and set ring using the special tool.
9. Install the knuckle in the reverse order of removal, and pay particular attention to the following items:
-
Be careful not to damage the ball joint boots when installing the knuckle.
-
Torque all mounting hardware to the specified torque values.
-
Torque the castle nuts to the lower torque specifications, then tighten them only far enough to align the slot with the pin hole. Do not align the
castle nut by loosening.
-
Install new cotter pins on the castle nuts after torquing.
-
Avoid twisting the sensor wires when installing the wheel sensor.
-
Before installing the brake disc, clean the mating surfaces of the front hub and the inside of the brake disc.
-
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
-
Check the front wheel alignment, and adjust it if necessary.
Dust Cover, Wheel Hub
Replacement
1. Remove the set ring and the boot.
2. Pack the interior of the boot and lip with grease. Do not contaminate the boot installation section with grease.
3. Wipe the grease off the sliding surface of the ball pin, and pack it with fresh grease. Keep grease off the boot installation section and the tapered
section of the ball pin. Do not allow dust, dirt, or other foreign materials to enter the boot.
4. Install the boot in the groove of the boot installation section securely, then bleed air.
