CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Control Arm Bushing: Service and Repair
Replacement
1. Remove the upper arm bushing and upper arm inner bushing as shown.
2. Mark a scribe line on the upper arm inner bushing so it is in line with the bolt mounting surface.
3. Make a mark on the upper arm at two points so the marks are in line and at a right angle with the arm as shown in the drawing.
4. Drive in the upper arm inner bushing with the marks aligned until the leading edge is flush with
5. Drive the upper arm bushing into the upper arm until the leading edge is flush with the upper arm.