CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
1. Shift the shift lever into N position.
2. Pull or push the wires to adjust the clearance between the wires and the edge of the shift lever control bracket to 13 mm (0.5 inch).
3. Secure the wires with the harness clamp.
4. Move the shift lever to each position, and verify that there is a clearance between the wires and bracket in each position.
5. If the wires are kept tight in any position, readjust the clearance.
6. Install the shift lever assembly on the steering column.
7. Move the shift lever to each position, and make sure that the wires are kept away from any parts such as the steering column.
Detent Spring Replacement
1. Install the detent spring on the shift lever control bracket, and install the screw loosely.
2. Shift the shift lever to N position.
