CR-V EX 4WD L4-1972cc 2.0L DOHC MFI (2000)
Carrier Bearings: Service and Repair
Bearing Outer Race Replacement
NOTE:
-
The bearing outer race and tapered roller bearing should be replaced as a set.
-
Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
1. Remove the oil seals from the transmission housing and clutch housing.
2. Drive the bearing outer race and thrust shim out of the transmission housing, or remove the bearing outer race and 75 mm shim from the clutch
housing by heating the clutch housing to about 212°F (100°C) with a heat gun. Do not reuse the thrust shim if the outer race was driven out.
