CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
-
Plug weld the holes areas of the dashboard lower and damper housing with a MIG welder.
10. Weld the wheelhouse upper member.
When the upper member is to be reused, make MIG plug welds at the drilled holes.
11. Finish the welded area. Use a hammer and dolly to even out the side bulkhead and front side frame flanges for close fit with the surface of the front
wheelhouse and damper housing.
12. Apply sealer to the mating surfaces of the lower dashboard and front side frame, etc..
13. Apply paint. See Paint Repair section.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection, and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames, or cigarettes.
14. Apply the undercoat. Undercoat the front floor, etc., and apply anti-rust agent to the inside of the welding section of the front side frame, lower
dashboard, and upper member, etc..
15. Install the related parts in the reverse order in which they were removed.
16. Inspect, check, and make adjustment.
-
Measure the front wheel alignment.
-
Inspect the brake system.
-
Adjust the headlight aim.
