CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
Air Bag(s) Arming and Disarming: Service and Repair
Before removing the airbag or SRS related devices (the SRS unit, the cable reel and the seat belt tensioner connector), disconnecting connectors from
related devices, or removing the dashboard or the steering column, disconnect the airbag connectors and seat belt tensioner connectors to prevent
accidental deployment.
WARNING: Turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at least three minutes before beginning
the following procedures A and B. (procedure B follows the procedure A.)
Before disconnecting the SRS main harness from the SRS unit, disconnect both airbags (C, D) and both seat belt tensioners (F, H).
Before disconnecting the cable reel 2P connector (B), disconnect the driver's airbag connector (C).
Before disconnecting the left side wire harness 2P connector (E), disconnect the driver's seat belt tensioner 2P connector (F).
Before disconnecting the right side wire harness 2P connector (G), disconnect the front passenger's seat belt tensioner 2P connector (H).
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the airbag and tensioner connectors .
Driver's Airbag
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel. When disconnected, the
airbag connector is automatically shorted.