CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
Horn Switch: Testing and Inspection
1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
2. Disconnect the driver's airbag and front passenger's airbag connectors.
3. Remove the driver's dashboard lower cover and the knee bolster.
4. Disconnect the cable reel sub-harness 3P or 6P connector from the main wire harness.
5. Check for continuity between the No.2 or No.3 terminal of the cable reel sub-harness and body ground with the horn switch pressed.
-
If there is continuity, the horn switch is OK.
-
If there is no continuity, go to step 6.
6. Remove the driver's airbag, then disconnect the horn connector from the steering wheel.
