CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
18. Install the backing plate/hub bearing unit on the trailing arm
19. Install the reverse order of removal, and pay particular attention to the following items.
-
Before installing the spindle nut, apply a small amount of motor oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
-
Avoid twisting the sensor wires when installing the wheel sensor.
-
Fill the brake reservoir and bleed the brake system.
-
Adjust the parking brake.
-
Check the rear wheel alignment, and adjust it if necessary.