CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
Auxiliary Power Outlet: Testing and Inspection
Front
1. Remove the center dashboard lower cover.
2. Disconnect the 2P connector from the front accessory socket.
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the No.1 and No.2 terminals.
-
There should be battery voltage.
-
If there is no battery voltage, check for:
-
blown No.27 (10 A) fuse in the under-dash fuse/relay box.
-
poor ground (G401, G402).
-
an open in the wire.
5. If all the tests prove OK, replace the front accessory socket.
