CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
5. Open the pressure control valve fully.
6. Start the engine and let it idle.
7. Turn the steering wheel from lock-to-lock several times to warm the fluid to operating temperature.
8. Measure steady-state fluid pressure while the engine is idling. If the pump is in good condition, the gauge should read 1,500 kPa (15 kgf/cm2, 213
psi). If it reads high, check the outlet hose or valve body unit.
9. Close the pressure control valve gradually and read the pressure.
CAUTION: Do not keep the pressure control valve closed more than 5 seconds or the pump could be damaged by overheating.
10. Immediately open the pressure control valve fully.
If the pump is in good condition, the gauge should read at least 6,900 - 7,800 kPa (70 - 80 kgf/cm2, 1,000 - 1,140 psi). A low reading means
pump output is too low for full assist. Repair or replace the pump.
