CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
1. Apply vinyl tape to the stepped portion of the pinion shaft, and coat the surface of the vinyl tape with the power steering fluid.
2. Install the backup ring ('97 model) or wave washer ('98- 01 models).
3. Coat the inside surface of the new valve oil seal with power steering fluid.
4. Install the valve oil seal with its grooved side facing opposite the bearing, then slide the valve oil seal over the pinion shaft, being careful not to
damage the sealing lip.
5. Apply vinyl tape to the splines and stepped portion of the shaft, and coat the surface of the vinyl tape with the Dower steering fluid.
6. Fit the new O-ring in the groove of the pinion shaft. Then slide the new valve seal ring over the shaft and in the groove on the pinion shaft.
7. Remove the vinyl tape from the pinion shaft.
8. Apply power steering fluid to the surface of the valve seal ring that was installed on the pinion shaft.
