CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
8. Check the dimensions, temporarily install the hood, front fender and headlight, and check for differences in level and clearance.
-
Check the engine and transmission mount brackets position.
9. Perform the main welding.
-
Weld as much as possible with the jig still mounted.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves, and safety shoes.
-
Make 20% to 30% more spot welds than there were holes drilled.
NOTE: If there isn't room for spot welds, compensate by using MIG welds.
