CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
30. Press the wheel bearing inner race from the hub using the special tool, a bearing separator, and a press.
31. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
32. Press a new wheel bearing into the knuckle using the old bearing, a plate, the special tool, and a press. Place the wheel bearing on the knuckle with
the pack seal side facing (metal color) toward the inside. Be careful not to damage the sleeve of the pack seal.
33. Install the shad ring securely in the knuckle groove.
34. Install the splash guard, and tighten the screws.
