CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
-
If the rivet depth is less than the service limit, replace the clutch disc.
INSTALLATION
1. Install the ring gear holder.
2. Apply grease to the spline of the clutch disc, then install the clutch disc using the special tools.
NOTE: Use only Super High Temp Urea Grease (P/N 08798 - 9002).
3. Install the pressure plate.
4. Torque the mounting bolts in a crisscross pattern as shown. Tighten the bolts in several steps to prevent warping the diaphragm spring.
5. Remove the special tools.
