CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
f.
Raise up the boot band tool to bend the free end of the band 90° to the clip. Center punch the clip, then fold over the remaining tail onto the
clip.
g. Unwind the boot banding tool, and cut off the excess free end of the band to leave a 5-10 mm (0.2-0.4 inch) tail protruding from the clip.
h. Bend the band end by tapping it down with a hammer.
NOTE:
-
Make sure the band does not move.
-
Remove any grease remaining in the surrounding surfaces.
