CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
Wheel Bearing: Service and Repair
Front Suspension
Replacement
Note these items during replacement:
-
Replace the self-locking nuts after removal.
-
The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushings are tightened.
-
Torque the castle nuts to the lower torque specifications, then tighten them only far enough to align the slots with each pin hole. Do not align the
nuts by loosening.
-
Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage the aluminum wheels.
-
On aluminum wheels, remove the center cap from the inside of the wheel after removing the wheel.
-
Before installing the brake disc, clean the mating surfaces of the front hub and brake disc.
-
Before installing the wheel, clean the mating surfaces of the brake disc and wheel.
-
Wipe off the grease before tightening the nuts at the ball joints.
1. Loosen the wheel nuts slightly.
2. Raise the front of the vehicle, and make sure it is securely supported.
