CR-V LX 2WD L4-1972cc 2.0L DOHC MFI (1998)
3. Measure the clearance between the reverse idler gear and reverse shift holder.
-
Standard: 0.5 - 1.1 mm (0.02 - 0.04 inch)
-
Service Limit: 1.8 mm (0.07 inch)
4. If the clearance is more than the service limit, measure the width of the reverse shift holder. Standard: 13.0 - 13.3 mm (0.512 - 0.524 inch)
NOTE:
-
If the width is not within the standard, replace the reverse shift holder with a new one.
-
If the width is within the standard, replace the reverse idler gear with a new one.