CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
3. Remove the mounting bolts from the distributor, then remove the distributor from the cylinder head.
Installation:
1. Bring the No.1 piston to compression stroke TDC.
2. Coat a new O-ring with engine oil, then install it.
3. Align the lug on the end of the distributor and its mating grooves in the camshaft end, then slip the distributor into position.
NOTE: The lug on the end of the distributor and its mating grooves in the camshaft end are both offset to eliminate the possibility of installing the
distributor 180 ° out of time.
4. Install the mounting bolts, and tighten them lightly.
5. Connect the ignition wires to the distributor cap as shown.
6. Connect the connector to the distributor.
7. Set the ignition timing.
8. After setting the ignition timing, tighten the mounting bolts.
