CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
32.
Reattach the brake booster hose, the cruise control vacuum line, the throttle cable, and the cruise control actuator cable to the bulkhead mounting
bracket.
33.
Fill the clutch master cylinder reservoir with Honda DOT 3 brake fluid, and bleed the system. Refer to step 4 on page 12-6 of the service manual.
34.
Reinstall the air cleaner housing and intake tube. Torque the mounting bolts to 9.8 N.m (7.2 lb-ft).
35.
Reconnect the negative battery cable to the battery.
36.
Adjust the clutch pedal position switch. While pulling the clutch pedal toward you, adjust the switch until the threaded body of the switch contacts
the pedal; then turn the switch in a 1/4 turn more, and lightly tighten the locknut.
37.
Depress the clutch pedal until it is 15 to 20 mm from the floor, and hold it there. Adjust the clutch interlock switch so that the engine will start with
the clutch pedal in this position.
38.
Torque the locknuts on both switches to 9.8 N-m (7.2 lb-ft).
39.
Test-drive the vehicle. Check for proper clutch operation, and make sure that the cruise control is cancelled by depressing the clutch pedal.
40.
Enter the customer's anti-theft code and radio station presets.
41.
Reset the clock.
