CR-V LX 4WD L4-1972cc 2.0L DOHC MFI (2000)
3. Apply a small amount of motor oil to the seating surface of the new spindle nut.
4. Install a new spindle nut, then torque the nut. After tightening, use a drift to stake the spindle nut shoulder against the driveshaft.
5. Clean the mating surfaces of the brake disc and the wheel, then install the rear wheel and torque the wheel nuts.
Overhaul
DISASSEMBLE
NOTE:
-
Due to the amount of work required to replace one damaged boot, it is best to replace both boots at the same time.
-
These instructions are for the inboard joint. The same procedure applies to the outboard joint.
1. Remove the set ring from the inboard joint.
2. Remove the boot band. If the boot band is a double loop type, raise the band bend.