CR-V LX 4WD L4-2.4L (2002)
13.
After completing the right edge, push all of the cam blades to the right until they touch the cams, then trace the cam blades from back to front.
(The cutter bit cuts the same contours into the left edge of the key from tip to head.) Turn off the cutter motor.
14.
Release the vertical carriage lever. Push all the cam blades to the left until they touch the cams. Pull the vertical carriage lever towards you until
the tracer touches the flat surface on the right side, at the front of the cams. Gently twist the lever clockwise to lock the vertical carriage at this
height. Do not overtighten the lever.
15.
Turn on the cutter motor, then retrace the cam blades from front to back. Push all the cam blades to the right until they touch the cams, and then
retrace the cam blades from back to front (retracing cleans up the cuts on the key). Turn off the cutter motor.
16.
Release the vertical carriage lever. Open the jaw and remove the key. Make sure the jaw is free of any metal shavings or debris. Turn the key over
so the blank side is up, then slide it into the jaw up to the key stop. Close the jaw to lock the key in place.
17.
Push all the cam blades to the left until they touch the cams. Repeat steps 10 through 15 to cut both edges on the other side of the key.
18.
When you are done making the required cuts, release the vertical carriage lever. Open the jaw and remove the key.
19.
Make sure the key works in the ignition switch and the locks. If the key does not work, recut the key, and try it again.
20.
Depending on the type of key, code the key transponder.
Equipment Service and Warranty
To service the MATRIX H Key Cutting Machine, refer to section 7 of the MATRIX H Operating Manual. It tells you how to replace parts that
commonly wear out such as the drive belt, the work light bulb, and the tension spring on the vertical carriage. It also covers checking and replacing fuses
and replacing the printed circuit board for the setting unit keypad.
If you have technical questions on the equipment, contact the Ilco Technical Assistance Department.
Mail:
Kaba Ilco Technical Assistance Department
400 Jeffreys Road
Rocky Mount, NC 27804
Phone: 800-452-6872 Ext: 200, 384, 323, 398, 356
Fax: 252-446-4702
The MATRIX H Key Cutting Machine comes with a 3-year limited warranty. This warranty does not cover the cutter bit or the work light bulb.
CODE BOOK CORRECTIONS
In the code book Honda High Security key Codes, correct these errors:
Pages 4 thru 51, code headings:
^
Incorrect: J H G F Z X E D C B M/S X
^
Correct: J H G F A X E D C B M/S X
Page 2, last paragraph:
