CR-V LX 4WD L4-2.4L (2002)
Use the double action sander and #6O~#8O disc paper.
-
Sand the area larger than the damaged area.
Use the double action sander and #1BO~#24O disc paper.
-
If a double action sander is not available use a rubber pad and wet or dry sandpaper.
Use the flexible block and #280, #340, #400, #600 sandpaper.
Damage to undercoat, intermediate coat and top coat:
Sand the damage area flat and smooth
Use the double action sander and #18O~#24O~#32O disc paper.
2. Preparation of metal surface Remove all corrosion from the damaged area.
Use a product that removes corrosion.
3. Air blowing/degreasing
Use alcohol, and wax and grease remover.
Treatment of Metal Surface
Treatment of Metal Surface
1. Filling/drying
Small cracks or pinholes in the sheet metal should be repaired with a body filler and sanded flat and smooth.
-
Use the 2-part polyester resin putty.
-
Mix the putty with the hardener in the correct ratio.
-
Follow the body filler manufacturer's instructions.
