CR-V LX 4WD L4-2.4L (2002)
8. Remove the parking brake cable (A) from the backing plate.
NOTE: The parking brake cable must not be bent or distorted. This will lead to stiff operation and premature cable failure.
9. Remove the wheel sensor (A) from the knuckle (if equipped with ABS).
10. Place a floor jack under the trailing arm (A) to support it.
NOTE: Do not place the jack against the plate section of the lower arm. Be careful not to damage any suspension components.
11. Remove the flange bolt, and disconnect the upper arm (B) from the knuckle.
