CR-V LX 4WD L4-2.4L (2002)
8. Connect the GRN test harness clip (D) to the positive probe of a voltmeter.
Is there 5 V or battery voltage?
YES - Go to step 9.
NO - Repair short or open in the BLU/WHT [WHT/ GRN] wire between the VSS and the ECM.
9. Turn the ignition switch OFF.
10. Connect the other test harness connector (A) to the VSS (B).
11. Raise the front of the vehicle, and make sure it is securely supported.
12. Put the vehicle in neutral with the ignition switch ON (II).
13. Slowly rotate one wheel with the other wheel blocked.
Does the voltage pulse from 0 to about 5 V or battery voltage?
YES - Go to step 14.
NO - Replace the VSS.
14. Disconnect the 22P connector "A" from the gauge assembly.
15. Touch the voltmeter positive probe to the gauge assembly A4 terminal, and connect the negative prove to body ground.
16. Slowly rotate one wheel with the other wheel blocked.
Does the voltage pulse from 0 to about 5 V or battery voltage?
