honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Fuel/Emissions - MIL ON/DTC P01456 (EVAP System)|Page 3869 > < Fuel/Emissions - MIL ON/DTC P01456 (EVAP System)
Page 2
background image

PARTS INFORMATION

WARRANTY CLAIM INFORMATION

In warranty: The normal warranty applies.

Failed Part:

P/N 17660-S9A-A01 
H/C 6887210

Defect Code:

03214

Symptom Code:

03203

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.

DIAGNOSIS

Remove the fuel fill cap, reinsert it, then tighten it. The cap should turn, without resistance, until its 0-ring touches the fuel fill pipe.

^

If the cap turns freely, this service bulletin does not apply; continue with normal troubleshooting.

^

If the cap binds or drags, go to REPAIR PROCEDURE.

REPAIR PROCEDURE A - CR-V

NOTE:

Make sure the fuel tank is less than half full before starting this procedure.

1.

Raise the vehicle on a lift, and remove the left rear wheel.

2.

Remove the three EVAP canister mounting bolts. Let the canister hang in place.

Fuel/Emissions - MIL ON/DTC P01456 (EVAP System)|Page 3869 > < Fuel/Emissions - MIL ON/DTC P01456 (EVAP System)