CR-V LX 4WD L4-2.4L (2002)
6.
Using a pry bar, move the rear cross beam down to make room to remove the fuel fill pipe.
7.
Install the new fuel fill pipe, the fuel fill pipe gasket, and the hoses. Torque the two cross beam bolts to 69 Nm (51 lb-ft). Reinstall the EVAP
canister and the wheel.
8.
Connect the HDS to the vehicle's DLC (data link connector), and do the EVAP function test:
^
From the HDS main menu, select Honda System.
^
From the Honda System menu, select PGM-FI.
^
From the PGM-FI menu, select Inspection.
^
From the Inspection menu, select EVAP Test.
^
From the EVAP Test menu, select Function Test.
^
Follow the instructions on the screen.
9.
Check the results of the EVAP function test.
^
If the vehicle passed the test, return it to the customer.
^
If the vehicle failed the test, do the DTC P1456 troubleshooting in section 11 of the appropriate CR-V service manual.
REPAIR PROCEDURE B - S2000
NOTE:
Make sure the fuel tank is less than half full before starting this procedure.
1.
Remove the left side trunk lining.
