CR-V LX 4WD L4-2.4L (2002)
the HIM from the vehicle.
7. Connect the PC interface cable to the iN workstation and to the HIM. Connect the power supply unit and power supply cord to the HIM. After
several seconds, the green and yellow LEDs flash.
Each updatable vehicle system is checked to make sure it is current. Any systems needing an update are listed on the screen. Highlight the system you
want to update, then click on the check mark to continue.
NOTE:
Update the systems one at a time.
8. Verify that the Program ID and the Program Part No. are correct, then click on the check mark.
9. Confirm the control module update by Program ID and Program Part No. Make sure this corresponds with any information provided in the service
bulletin for the update you are doing. Click on Yes to continue. Within a few seconds, the CM Update software loads the program file onto the HIM.
10. Disconnect the HIM from the PC interface cable.
11. Reconnect the HIM to the vehicle's DLC.
12. Turn the ignition switch to ON (II), and wait until the green No.1 LED on the HIM stays on. Press and release the ENTER button on the HIM.
