CR-V LX 4WD L4-2.4L (2002)
No. 1, No. 2, No. 3, No. 5 and body ground.
Shift solenoid valve A: No. 5 terminal (BLU)
Shift solenoid valve B: No. 2 terminal (ORN)
Shift solenoid valve C: No. 1 terminal (GRN)
Shift solenoid valve E: No. 3 terminal (RED)
STANDARD: 12 - 25 Ohms
9. If the resistance is out of standard, disconnect the shift solenoid valve connector, and measure its resistance at the solenoid valve connector.
Replace the shift solenoid valve if the resistance is out of standard.
10. Connect the battery positive terminal to the shift solenoid harness connector terminals, and connect the battery negative terminal to body ground
individually. A clicking sound should be heard.
11. If no sound is heard, connect the battery positive terminal to the shift solenoid valve connector terminal, and check the clicking sound is heard.
Replace the shift solenoid valve if no sound is heard.
12. Replace the solenoid harness if the tests results are OK.
13. Install the new O-ring on the shift solenoid harness connector, and install the connector in the transmission housing.
14. Install the shift solenoid valve cover with the new gasket and dowel pins.
15. Install the ATF cooler inlet line with the line bolt and the new sealing washers. Create clearance with the jack between the transmission and the
front sub-frame to tighten the line bolt with the torque wrench.
16. Install the bracket of the ATF cooler inlet line on the shift solenoid valve cover with the bolt.
17. Check the connector for rust, dirt, or oil, then connect the connector securely.
18. Remove the transmission jack.
19. Refill the transmission with the recommended fluid.
