CR-V LX 4WD L4-2.4L (2002)
*
NOTE:
If you cannot remove the terminals, go to step 19.*
12.
Check the condition of the terminals:
*
^
If any of the terminals are damaged or contaminated with oil or grease, go to step 19.
^
If no terminals are damaged or contaminated with oil or grease, go to step 13.*
13.
Transfer the terminals to the new connector in the correct order: YELLOW, BLACK, GREEN, WHITE.
14.
After transferring the terminals to the new connector, gently pull on each wire to make sure the terminals are engaged.
15.
Insert a new lock tab into the connector.
16.
Reconnect the cable reel 4P connector to the driver's airbag 4P connector, then reattach the cable reel connector. Reinstall the access panel on the
steering wheel.
17.
Reconnect the negative cable to the battery.
18.
Turn the ignition switch to ON (II), and watch the SRS indicator.
^
If the indicator goes off within 10 seconds, go to step 20.
^
If the indicator does not go off within 10 seconds, go to step 19.
19.
Replace the cable reel.
^
Refer to page 23-137 of the 2002-04 CR-V Service Manual.
*
^
In ISIS, enter keyword REEL, and select Cable Reel Replacement from the list.*
20.
Do the idle learn procedure:
^
Make sure all electrical items (A/C, audio unit, defogger, lights, etc.) are off.
^
Start the engine, and let it warm up to its normal operating temperature (the cooling fans cycle twice).
^
Let the engine idle (throttle fully closed and all electrical items off) for 10 minutes.
21.
Initialize the driver's window auto-up feature:
*
^
Turn the ignition switch to ON (II).*
^
Make sure the driver's window is fully closed.
^
Push down and hold the window switch until the window goes all the way down.
^
Pull back and hold the window switch until the window goes all the way up, then hold the switch for at least 2 more seconds.
22.
Enter the radio anti-theft code, and set the clock. If you are working on a customer's vehicle, enter the radio station presets.
