CR-V LX 4WD L4-2.4L (2002)
56. Set the new bushing (A) on the special tool, and insert the special tools into the cylinder housing (B).
57. Set the cylinder in a press, and install the bushing (A) into the bottom of the cylinder by pressing on the tool with press. Do not push on the tool
with excessive force as it may damage the new bushing.
58. Coat the sliding surface of the special tool (A) and new cylinder end seal (B) with power steering fluid. Place the seal on the special tool with its
grooved side (C) facing opposite the special tool.
59. Apply a thin coat of grease to the inside of the special tool.
60. Install the cylinder end seal (A) onto the steering rack (B) with its grooved side (C) toward the piston (D). Make sure the gap in the special tool is
opposite of rack teeth.
