CR-V LX 4WD L4-2.4L (2002)
91. Close the ear portion (A) of the bands (B) with a commercially available pincers, Oetiker 1098 or equivalent (C ).
92. Install the rack end plug (A).
93. Clean off any grease or contamination from the boot installation grooves (C) around on the housing.
94. Slide the steering rack, and adjust the distance between the cylinder housing end and the end of the rack end plug to 70.5 mm (2.8 inch). Install
boot (B), and set the boot end in the installation grooves in the cylinder housing and rack end plug properly. Install the clip (D) and boot guard
(E). Install the new boot band (F) in the band grooves of boot (B) by aligning the tabs (G) with the holes (H) in the band.
95. Close the ear portion (A) of the band (B) with a commercially available pincers, Oetiker 1098 or equivalent (C). Slide the rack right and left to be
certain that the boots are not deformed or twisted.
