CR-V LX 4WD L4-2.4L (2002)
16. Install the shift lock solenoid plunger (A) and plunger spring (B) in the new shift lock solenoid (C).
17. Install the shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock stop (D).
18. Route the harnesses, and clamp them as shown.
19. Install the O/D switch harness terminals (A) in the No. 5 and No. 6 cavities. Either O/D switch harness terminal can be installed in the No. 5 and
No. 6 cavities.
20. Install the park pin switch harness terminals (B) in the No. 1 and No. 2 cavities. Either park pin switch harness terminal can be installed in the No.
1 and No. 2 cavities.
21. Install the BLU harness terminal (C) of the shift lock solenoid in the No. 3 cavity and the RED harness terminal (D) in the No. 4 cavity. Make sure
that all six terminals lock securely, then install the lock (E) securely.
