CR-V LX 4WD L4-2.4L (2002)
Windshield Washer Spray Nozzle: Technical Service Bulletins
Windshield Washer Nozzle Troubleshooting
SOURCE:
Honda Service News April 2003
TITLE:
Troubleshooting Windshield Washer Nozzle Problems
APPLIES TO:
2003 Accords, 2001-03 Civics, 2002-03 CR-Vs, 2003 Elements, 1999-03 Odysseys, and 2003 Pilots.
SERVICE TIP:
Warranty Parts Inspection (WPI) tested windshield washer nozzles that were replaced because they were "inoperative" or "did not work properly." Every
one of the nozzles tested was determined "no trouble found." To cut down on unnecessary nozzle replacement and a possible warranty debit to your
dealership follow these tips to fix windshield washer nozzle problems.
Washer nozzle doesn't work. If the washer nozzle doesn't work, it's most likely clogged or frozen. If the nozzle is clogged, remove it, and blow some
compressed air out through the nozzle to clear it. Then, before you reconnect the nozzle, run the washer pump to flush out any debris from the hoses.
If you suspect the washer didn't work because it was frozen, replacing the nozzle won't fix the problem. Drain and refill the washer reservoir with a
washer fluid that doesn't freeze.
Washer nozzle doesn't work properly. If the washer nozzle isn't aimed right, adjust the ball shaped nozzle; don't replace the nozzle. To adjust the
nozzle, use a small, flat-tip screwdriver to push on the deflector and move the ball. Never stick a needle or any such object in the nozzle. Adjust the
nozzle so the center of the spray hits the middle of the windshield.
