CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
23. Position the lever arm under the cross shaft so the lever is perpendicular to the shaft and the compressor attachment rests on top of the retainer for
the spring being compressed. Use the rear position slot on the lever as shown.
24. Using a downward motion on the lever arm, compress the valve spring and remove the keepers from the valve stem. Slowly release pressure on the
spring.
25. Repeat step 24 for the other valve in that cylinder.
26. Remove the valve seals.
27. Install the valve seals.
28. Install the springs, the retainers and the keepers in reverse order of removal.
29. Repeat steps 21 to 28 on the other three cylinders.