CR-V SE 4WD L4-1972cc 2.0L DOHC MFI (2001)
6. Disconnect the connector from the evaporator temperature sensor, and remove the wire harness from the evaporator. Remove the self-tapping
screws, the mounting bolt and the mounting nut. Disconnect the drain hose, then remove the evaporator.
7. Install in the reverse order of removal, and note of these items.
-
If you're installing a new evaporator, add refrigerant oil (SP-10).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right
O-rings for HFC-134a (R-134a) to avoid leakage.
-
Apply sealant to the grommets.
-
Make sure that there is no air leakage.
-
Charge the system , and test its performance.
